SIZE 9 MEDIUM

BLACK, GREY & YELLOW

VELCRO WRIST BAND

CUT LEVEL 5 (D) & IMPACT RESISTANT GLOVES

SIZE 10 LARGE

BLACK, GREY & YELLOW

VELCRO WRIST BAND

CUT LEVEL 5 (D) & IMPACT RESISTANT GLOVES

British Rail, Network Rail, Rail

SOCKET, IMPACT, BI-SQUARE, 1-1/8" X 1" DRIVE, AS CHAIR SCREW

50mm pin
500mm ring suits this socket

STEL 20mm M42 Rail Cutter Short Series

STEL 19mm M42 Rail Cutter Short Series

STEL 17mm M42 Rail Cutter Short Series

STEL 16mm M42 Rail Cutter Short Series

Suitable for use on FASTCLIP FC, FASTCLIP FE, VIPA-SP and SFC fastenings. The new tools, which react from the rail, are more efficient, faster and safer because they are not prone to slipping from the shoulder reaction points. Additionally, the tools offer compatibility with a wide range of Pandrol systems, including FASTCLIP ‘FC’ & FASTCLIP ‘FE’ and the Pandrol VIPA-SP & SFC baseplates. Finally, because the reaction point for the installation tool has been moved to the head of the rail, the installer is able to lift sleepers (about 20mm) as part of the normal action of the tool, lifting from the rear arches of the clip before driving the clip into the installed position. NOTE: This tool has options avaialble under separate reference numbers; for variants with either insulated handles and / or cranked heads for confined spaces. The standard tool is always supplied with a straight head and steel handle. Optional variant of this tool using cranked head for confined spaces and insulated handle To insert the clips from the ‘Parked’ position of the shoulder as delivered from the sleeper factory, follow these instructions. The paddle should be in the normal front pivot hole and the side cheeks in the down position. (Different from the photograph) for ALL rail sizes. Locate the hooks on the side arms over the head of the rail. To insert the clips, grasp both handles of the ‘Tee’ bar, and stand ‘naturally’ with feet apart then move one leg half a pace back, to prevent loss of balance during clip driving. Pull on the handle until refusal. The fully driven position for FASTCLIP ‘FC’ is achieved when the outer legs of the clip touch the rear of the side insulator in the shoulder, or with up to 3 mm of clearance. The FASTCLIP ‘FE’ installed position does NOT touch the shoulder or insulator. Once located the tool can be slid along the rail between sleepers for the next clip insertion. If the clip needs to be re-inserted from fully extracted, move the cheeks to the up position, to extend the reach of the tool. If more reach is required, the paddle can be moved to the rear pivot hole. Follow the instructions above.

TYPE FAST CLIP FC EXTRACTOR - FRANCE TYPE FASTCLIP FC OUTIL MANUEL D'EXTRACTION

28mm x 450mm Hexagon Breaker Point Steel to suit BOSCH GSH2Y and GSH16-28 Breakers.