Socket Retaining Pin 55mm x 5mm

Socket Retaining Pin 65mm x 5mm

Cut 5 Safety Gloves, Protection against cutting - Level 5, Conforming to Standards EN 420, EN 388

Cut 5 Safety Gloves, Protection against cutting - Level 5, Conforming to Standards EN 420, EN 388

Size 9 (L)

Cut 5 Safety Gloves, Protection against cutting - Level 5, Conforming to Standards EN 420, EN 388

Size 10 (XL)

Cut 5 Safety Gloves, Protection against cutting - Level 5, Conforming to Standards EN 420, EN 388

Size 11 -X-Large

• Thermal grip glove - conforms to EN388
• Seamless 10 gauge premium quality
• Suitable for cold conditions and outdoor heavy duty tasks
• Black latex crinkle finish on warm acrylic liner with elasticated knitwrist for secure fit
• Applications: Construction, Transportation, Refuse collection, Maintenance, Local authority.
• Material: Acyrlic / Latex

• Rail Tongs manufactured from forged steel.
• Designed to accommodate a range of rail sections.
• Hi-Vis Yellow

Rear arch extractor for FASTCLIP ‘FC PANDROL No. LP15177 The rear arch extractor remains available to extract clips around IBJ’s. This tool is ONLY needed at IBJ’s in order to extract clips which are shielded by the scalloped section of the joint. It is also unique to FASTCLIP ‘FC’ and does NOT work with ‘FE’ clips. Instructions for Rear Arch Extractor The hooks in the frame of the tool locate into the reaction points on the shoulder, as shown in the photograph. The clip is extracted using the tines inserted in the rear arches of the clip. Once located grasp both handles of the ‘Tee’ bar, and stand ‘naturally’ with feet apart then move one leg half a pace back, to prevent loss of balance during clip extraction. Push the handle away to extract the clip, stopping at the ‘Parked’ position, or continuing to push away to fully extract the clip from the shoulder.

Cat No Reference: 0039/47852 Suitable for use on FASTCLIP FC and FASTCLIP FE The original version of the sleeper lifter can still be used in conjunction the new installer where sleepers need to be lifted more than 20mm. Instructions for Sleeper Lifter LP12608 The scissor action of the frame opens in order to locate the pincers of the tool into the sides of the shoulder with the clip in the ‘Parked’ position. Place the hook of the tool over the head of the rail, and as the body of the tool rises the scissor action closes the pincers and lock into the shoulder. Once located grasp both handles of the ‘Tee’ bar, and stand ‘naturally’ with feet apart then move one leg half a pace back, to prevent loss of balance during sleeper lifting. Push the handle away to lift any ‘dropped’ sleeper if ballast conditions do not support the sleepers engaging with the foot of the rail. These tools should be used in pairs to lift the sleeper to locate both rails simultaneously with the rail seats of the sleeper. The sleeper lifter can used on the same rail seat as the FASTCLIP installer, by locating between the hooks of the installation tool.