This versatile jack is designed, by means of a removable slewing shoe, for slewing, aligning and lifting railway tracks, points and crossings. The jack is obstructionless to prevent traffic interruption, will slew up to 50mm, and is fitted with an overload safety valve. Lifting Capacity 5t - shoe, 7t - head Lift on Shoe 160mm Lift per pump stroke 4mm - shoe Weight of Jack 24.5kg Weight of Shoe 3.5kg Weight of Standard Lever 2.2kg

Supplied with an overload safety valve and tested to 25% over the rated capacity. Designed for use on switches and crossings, this heavy duty jack is obstructionless for rails 42kg/m and over. Safe working load: 20t - head, 15t - toe Closed height: 343mm - head, 191mm - toe Toe to head: 152mm Lifting stroke: 110mm Weight: 36kg

Reduced shank for smaller diameter cutters

Reduced shank for smaller diameter cutters

PANDROL No. LP7632 Especially for e2001 and e2007clips but NOT for 4-shoulder baseplates. NOTE hook positions for max efficiency: Upper pivot: Clip installation Lower pivot: Clip extraction All Pandrol hand-tools can be supplied with optional insulated handles, which have recently been upgraded to 35mm diameter cylindrical handles with ‘T’ cross bars for improved ergonomic and safer use. Installation Instructions ​• Insert center leg of clip into housing. • Place pivoted hook over the inside of the front arch of clip with foot of PANPULLER behind clip housing and ensure lip of the hook is under the front arch. • Taking up a natural stance with feet apart, move one leg half a pace back to prevent loss of balance. Stand behind the PANPULLER, with both hands on tee handle at top of PANPULLER, pull strongly towards chest until refusal. • The PANPULLER automatically pulls clip to the correct position Extraction Instructions Reverse the PANPULLER

Used in conjinction with both the EVSR & FVSR stressing rollers

TONGS FOR NWR CONCRETE CROSSING BEARER URLT/023118 0039/068275

STRESSING ROLLER, E-CLIP, UNDER / BOTTOM

BS8020 Insulated Fibreglass Pick Shaft. Pultruded fibreglass core with an injection moulded polypropylene outer. BS Standard 3'' x 2'' eye. Tested and made in conformance with BS8020:2011. Tools for live working. This shaft is designed to be a tap on fit, however when fitting a replacement shaft, the eye should be dressed to suit the hammer head by a competent person.

550 lumen white Nichia LED, 6500k ƒ Hard anodized die cast matte aluminium body ƒ Tactical rubberised micro switch operation ƒ 3 light mode settings and 8Hz defence strobe ƒ Flawless smooth reflector for long distance beam ƒ IP67 dust and waterproof - 1m submersible ƒ Impact resistant to 1m ƒ Built-in USB rubberised charging port cover ƒ Battery level and charging indicator LED ƒ 1A USB-C charging - fast 2 hours charge time ƒ High quality USB-C charging cable included ƒ Nylon velcro holster & safety nylon wrist strap