Suitable for use on FASTCLIP FC, FASTCLIP FE, VIPA-SP and SFC fastenings. The new tools, which react from the rail, are more efficient, faster and safer because they are not prone to slipping from the shoulder reaction points. Additionally, the tools offer compatibility with a wide range of Pandrol systems, including FASTCLIP ‘FC’ & FASTCLIP ‘FE’ and the Pandrol VIPA-SP & SFC baseplates. Finally, because the reaction point for the installation tool has been moved to the head of the rail, the installer is able to lift sleepers (about 20mm) as part of the normal action of the tool, lifting from the rear arches of the clip before driving the clip into the installed position. NOTE: This tool has options avaialble under separate reference numbers; for variants with either insulated handles and / or cranked heads for confined spaces. The standard tool is always supplied with a straight head and steel handle. Optional variant of this tool using cranked head for confined spaces and insulated handle To insert the clips from the ‘Parked’ position of the shoulder as delivered from the sleeper factory, follow these instructions. The paddle should be in the normal front pivot hole and the side cheeks in the down position. (Different from the photograph) for ALL rail sizes. Locate the hooks on the side arms over the head of the rail. To insert the clips, grasp both handles of the ‘Tee’ bar, and stand ‘naturally’ with feet apart then move one leg half a pace back, to prevent loss of balance during clip driving. Pull on the handle until refusal. The fully driven position for FASTCLIP ‘FC’ is achieved when the outer legs of the clip touch the rear of the side insulator in the shoulder, or with up to 3 mm of clearance. The FASTCLIP ‘FE’ installed position does NOT touch the shoulder or insulator. Once located the tool can be slid along the rail between sleepers for the next clip insertion. If the clip needs to be re-inserted from fully extracted, move the cheeks to the up position, to extend the reach of the tool. If more reach is required, the paddle can be moved to the rear pivot hole. Follow the instructions above.

LED WARNING LIGHT

ATEX - 350 LUMEN CREE LED ZONE 0 INTRINSICALLY SAFE RIGHT ANGLE TORCH IP54 4 x AA (NOT INC)

DATA SHEET

ATEX - 150 LUMEN CREE LED ZONE 0 INTRINSICALLY SAFE IP67 3M SUB. FLASHLIGHT 4 x AA (NOT INC)

DATA SHEET

450 LUMEN CREE LED FOCUS ALUMINIUM FLASHLIGHT C/W WRIST STRAP AND IN A CLEAR HARDCASE DISPLAY BX - 4 x AAA DURACELL BATTERIES (INC)

DATA SHEET

1100 LUMEN CREE LED USB RECHARGEABLE ALUMINIUM FLASHLIGHT WITH BELT POUCH AND WRIST STRAP - REMOVABLE 3.7v 2600mAh 18650 LI-ION BATTERY

DATA SHEET

1000 LUMEN COMPACT WORK LIGHT WITH 300 LM TOP TORCH AND FOLDING MAGNETIC HANDLE/STACK/HOOK - 3.7v 5200mAh LI-ION INTEGRAL BATTERY - MICRO-USB CABLE (INC)

500 LUMEN COMPACT WORK LIGHT WITH 300 LM TOP TORCH AND FOLDING MAGNETIC HANDLE/STAND/HOOK - 3.7v 2000mAh LI-ION INTEGRAL BATTERY - MICRO-USB CABLE (INC)

625 LUMEN COB LED USB RECHARGEABLE INSPECTION LIGHT WITH TOP TORCH AND MAGNETIC BACK

275 LUMEN SMD LED USB RECHARGABLE INSPECTION LIGHT WITH 250 LUMEN CREE TORCH IN TOP AND ROTATING MAGNETIC STAND - 3.7v 1600 mAh LI-ION INTEGRAL BATTERY - MICRO-USB CABLE (INC)