Battery and fast charger included: the battery-powered hedge trimmer HGE 18-50 Battery Set. Its 180° rotating handle and the cuttings sweeper ensure convenient hedge cutting.

For effortless manoeuvring in the garden: the lightweight and extremely manoeuvrable battery lawn mower LMO 18-33 Battery Set including battery and fast charger.

IperCleaner - Hand Sanitiser Anti Bacterial Gel 200ml - 70% Alcohol IPERCLEANER is an antibacterial disinfectant gel, specially made to easily sanitize the hands without the need for rinsing. By acting in seconds, it removes 99% of viruses, bacteria and fungi. Its formula, suitable for daily use, allows you to disinfect your hands effectively, quickly and safely, in any situation and condition. IperCleaner is the best solution for guaranteed hygiene whenever there is no possibility to wash your hands. IPERCLEANER GEL Hand Sanitizer is practical in any situation where you need to disinfect your hands: away from home, when you cannot wash your hands (for example: on the road, on public transport, after touching money, etc.), in the hospital sector and professional, at home (in taking care of the patient). Pour on the palm of the hand a sufficient amount of product to cover the entire surface of the hands and rub for 30 seconds. Repeat the operation. The product is used without water. This item contains - Alcohol Denat., Aqua, Glycerin, Carbomer, Parfum, Aminomethyl Propanol, Propylene Glycol.

Suitable for use on FASTCLIP FC, FASTCLIP FE, VIPA-SP and SFC fastenings. The new tools, which react from the rail, are more efficient, faster and safer because they are not prone to slipping from the shoulder reaction points. Additionally, the tools offer compatibility with a wide range of Pandrol systems, including FASTCLIP ‘FC’ & FASTCLIP ‘FE’ and the Pandrol VIPA-SP & SFC baseplates. Finally, because the reaction point for the installation tool has been moved to the head of the rail, the installer is able to lift sleepers (about 20mm) as part of the normal action of the tool, lifting from the rear arches of the clip before driving the clip into the installed position. NOTE: This tool has options avaialble under separate reference numbers; for variants with either insulated handles and / or cranked heads for confined spaces. The standard tool is always supplied with a straight head and steel handle. Optional variant of this tool using cranked head for confined spaces and insulated handle To insert the clips from the ‘Parked’ position of the shoulder as delivered from the sleeper factory, follow these instructions. The paddle should be in the normal front pivot hole and the side cheeks in the down position. (Different from the photograph) for ALL rail sizes. Locate the hooks on the side arms over the head of the rail. To insert the clips, grasp both handles of the ‘Tee’ bar, and stand ‘naturally’ with feet apart then move one leg half a pace back, to prevent loss of balance during clip driving. Pull on the handle until refusal. The fully driven position for FASTCLIP ‘FC’ is achieved when the outer legs of the clip touch the rear of the side insulator in the shoulder, or with up to 3 mm of clearance. The FASTCLIP ‘FE’ installed position does NOT touch the shoulder or insulator. Once located the tool can be slid along the rail between sleepers for the next clip insertion. If the clip needs to be re-inserted from fully extracted, move the cheeks to the up position, to extend the reach of the tool. If more reach is required, the paddle can be moved to the rear pivot hole. Follow the instructions above.

ATEX - 225 LUMEN CREE LED ZONE 0 INTRINSICALLY SAFE IP67 1m SUB. HEADLIGHT 3 x AAA (NOT INC)

DATA SHEET

ATEX - 150 LUMEN CREE LED ZONE 0 INTRINSICALLY SAFE IP67 3M SUB. FLASHLIGHT 4 x AA (NOT INC)

DATA SHEET

DATA SHEET